The tripod is usually used with the winch, speed differential and other equipment. It is a multi-functional, multi-purpose, portable device that can be moved at any time. The device is widely used in high-rise buildings, deep wells, confined space and other occasions. When using the product, it shall not exceed its load limit and can not be used for purposes other than the design.
Material: aluminum alloy+steel
Height: 1.5-2.2m
Max capacity: 500kg
Static strength: 15KN
Winch size: 5mm galvanized steel wire rope, 20m
Total weight: 37.5kgs
Installation steps:
Step 1: Remove the tripod from the storage bag and put it flat on the ground；
Step 2: Pull the ¢10mm Quick release pin [2] at the bottom of the tripod supporting leg [1], pull out the inner pipe of the supporting leg, and fix it in the second or third hole of the supporting leg inner tube;
Step 3: Put the tripod on the plane, pull the three supporting legs out to the top fixed pin [3] stuck into the outer pipe fitting hole of the support leg, adjust the use span of the tripod, check that the three fixed pins are stuck into the outer pipe fitting hole of the support leg, and the support leg cannot be moved outward or inward;
Step 4: Select the supporting leg with the winch fixed, install the winch set [4], use the two ¢10mm Quick release pins[2], insert them to the two matching hole at the lower end of the base of the winch and the fixed holes of the supporting leg;
Step 5: Pull out the two pulley fixed pin [6] of the top guide pulley [5], and the wire rope with the safety hook from the winch [4] passes through the top guide pulley [5], then pass through the guide hole in the middle of the top disc [7] perpendicular to the ground, and then the two pulley fixed pin [6] is inserted into the guide pulley [5] to prevent the wire rope from running out of the pulley;
Step 6: After the above operation is completed, pull out the ¢10mm Quick release pins[2], pull the inner pipe of the supporting leg for height adjustment, after the adjustment in place, put the ¢10mm Quick release pins[2] into the fitting hole of the supporting leg, check that the inner tube can not be pumped again, it can be used;
Step 7: After the adjustment is completed, put the anti-slip chain [8] into the ring hole fixed by the ground foot, and then fix the O-fixed hook.
Step 8: According to the actual use of the needs of optional ground nails, explosion-proof fan use.
